Lane Conditions and Cold Snaps
In last month's article, we touched base on some of the effects weather can have on lane machines, lane conditioner, and ball motion. We wrote about these effects in the sense that the environment has already become more stable. But because of a few recent technical calls, we have decided to release a Special Edition of THE INSIDE LINE, and continue the discussion on how weather can affect lane conditions.
We have found that the biggest problem in a bowling center occurs when there is a drastic and quick temperature change. Kegel's lead chemist and VP of Chemical Product Development, Dennis Sheirs, found this out during the U.S. Open in 1998. For the first two days of the tournament the air conditioner wasn't working in the bowling center, and it was 80 degrees inside the center, and on the lanes.
Sometime in the middle of the afternoon on the second day of the tournament the air conditioning was fixed. Then during that evening someone cranked the air conditioning way down and by the next day both the bowling center, and the lane temperature were 60 degrees.
The bowlers started practice that morning and found the lane pattern played 10 boards tighter. Luckily, since Kegel was doing the lanes and strictly following our Process Verification Procedure, we could prove it wasn't because the laneman or lane machine did something different. But we did learn a valuable lesson; when doing lanes take control of the climate control system!
How does this affect you in daily life?
We find the same thing can happen when you typically get a cold snap up north and it's instant. Normally you will see everything get a little tighter at first. Then as everything goes through equilibrium, and bowling centers kick on the heat, all the other properties change and eventually everything will settle back in. That's when the lanes will start to hook more from the point where they got tighter at.
We said before that when the temperature of lane conditioner gets lower, the viscosity goes up, but that's only one part of the equation. The other part of the equation is the surface tension also increases, which makes the lane conditioner move more until everything settles back down. This can last over a week because during a cold snap the whole system is in flux.
What else can the weather do to my lanes?
During the summer time when the humidity is typically greater, synthetic lanes on top of wood lanes tend to be a bit more crowned towards the gutter outside of the second arrow. We know from our testing, crowned lanes tend to create "hang spots".
But in the winter time, when the heat is turned on in the bowling center or humidity decreases, the wood lane tends to depress, or the crowns decrease, and the panels follow that change in lane shape. This makes it easier for the ball move more towards the center - in other words, hook more. That change however takes a few weeks to fully occur.
If your located in an area that gradually gets colder throughout the year, you won't experience drastic changes because everything is just slowly moving there.
But from our experience, in most scenarios, those quick "cold snaps" (change from warm to cold), tend to make lanes play tighter first. Then, as the inside environment equalizes and the heater settles things down, lanes depress, and that's when we see more hook again.
So as we stated before, typically in the summertime, synthetic lanes installed over wood lanes tend to crown a little bit, and in the winter time, they tend to depress. When measuring lanes using the Kegel LaneMapper, we have documented examples of lanes changing up to .070" from summer to winter and back again - high humidity can create crowns and low humidity releases moisture causing the lane to depress.
In our research, we have found this drastic lane shape change happens only when synthetic panels are on top of existing older wood lanes. Synthetic panels on top of other substrates like MDF/HDF, or LSL do not show much change from summer to winter - only a few thousands of an inch.
Extreme lane shape change by overlays on top of wood lanes is caused by the wood lane underneath becoming "looser and looser" from years of not receiving attention as they did when resurfaced regularly. Basically, the toes screws that hold the boards together, and the screws holding the wood lane to the levelers, start backing out from the constant pounding of the bowling ball, making the wood lane act like an accordion.
Read more about Changing Lanes...
What do we suggest for quick weather changes?
Don't respond to the change too fast - give everything a chance to settle down and get back into equilibrium. Most of the time, our first response is we have to change something when somethings goes haywire - it's human nature.
You are better off to first perform your Process Verification Procedures to ensure your machine is operating correctly, your cleaner is being mixed correctly, and if so, just let everything settle down. Otherwise, you're going to be trying to change something while everything is transitioning.
A non-bowling analogy to the transition is like when you get into a pool for the first time. The water may feel cold, and that could be your first reaction, but if you stay in for a little while, you start to adjust to the temperature. Your core body temperature does not change; you just begin to acclimate to it.
After everything have settled down though, it may be entirely possible you have to adjust your oil pattern in order to keep your bowlers closer to what they are used to. For that just give us a call - the Kegel LaneMapper has provided us with insight and allows us to provide answers much quicker than in the past.
To end, and we can't stress enough, every center is unique and the solutions to any problems are just as unique. Just know that Kegel's Tech Support department is full of dedicated people trying to do the same thing you are; provide our customers with the best possible experience as we can. And don't forget, we are only a free phone call away.
